Capagri - Rollers

All our rollers are made from semi-steel, rubberised or non-rubberised, assembled with 2 double sealed
roller bearings. A hollow bearing pin for the M16 M18 or M20 bolt, or the M16, 18, 20 or 24 output shaft.

For ease of fixture all the output shafts of the rollers are 6 sided on their extremity, and some models
also have a half-flat on the entire shaft length.

The list of rollers shown below is not exhaustive. If however, you cannot find your roller, tell
us the dimensions and the shaft type.

See the catalog to find BROEKEMA references

CAST IRON WITHOUT FLANGE - HS Z type		CAST IRON WITH FLANGE - HS type

RUBBER WITHOUT BASE - HS RZ type		RUBBER WITH BASE - HS R

TRIANGULAR SHAKER - see catalog		OVAL SHAKER - HSA 42 only

Please fill out the form below to receive a quote.
We will get back to you as quickly as possible.
Only the fields preceded by a * are mandatory: (the surname and,
either the e-mail address, the telephone number, or the mobile number)

Please, fill your Surname Please, fill your e-mail address, the telephone number, or the mobile number Please, answer to the antispam question

* Surname		Address
First Name		Town/City
* E-mail		Country
* Telephone		Postal Code
* Mobile		Fax
		Roller without flange Roller with flange
		Cast iron roller Rubberised roller
Roller dimensions
Flange diameter
Diameter support
Width support
Type of shaft		hollow Output threaded
Dimensions of the shaft
Diameter
Length

Antispam Question What is the result of : 13 + 11 =

Back to the top